Electricity types

Electron flow in a cross-section of wire: Top- In a direct current circuit, the electrons only flow in one direction from positive to negative. Bottom- In an alternating current circuit the electrons flow in both directions as positive and negative alternate.

Voltage over time: Direct current maintains a steady voltage (red). Alternating current switches back and forth (blue).

There are two types of electricity – Alternating Current (AC) and Direct Current (DC). These two terms describe the way in which the current flows in a circuit. In a DC circuit, the current only flows in one direction, meaning that they have a constant positive (+) and negative (-). This relationship of positive to negative charge is referred to as polarity. In an alternating current circuit, current flow changes direction regularly, switching the polarity (positive (+) and negative (-)) each time. This back and forth switching of polarity in an alternating current circuit is reffered to as frequency and is measured in Hertz (Hz). Polarity in a typical AC circuit switches between 50-60 times per second meaning that the circuit has a frequency of 50-60Hz.

In any electrical system, whether AC or DC, all components or appliances must be rated to function with the characteristics of the electrical system - voltage, current, and frequency if AC. If they are used improperly it can lead to a failure that results in fire or injury.

Direct current

PV modules can only produce DC, thus all PV systems have at least one DC circuit. Anything that uses a battery, including PV systems, will be based on DC as batteries can only store energy in DC form. Powering a load directly from DC saves the step of having to use an inverter to convert from DC to AC, which can create losses of more than 10% in the process. Many small scall systems are DC only and work well for lightning and the charging of small electronic devices like cell phones.

Alternating current

The grid is almost entirely built to function with alternating current, although the voltage, frequency and number of wires varies around the world. Nearly all electronic devices - cell phones, radios, computers and televisions - run on DC internally, but because they are typically designed to function with the grid they incorporate electronics to convert from AC to DC. Appliances with motors or compressors - refrigerators, fans and tools - have motors that can run directly on alternating current. Most countries use different voltages for differnet service types (residential, commercial, industrial). Some countries also have voltages and frequencies that vary based upon location as the grid has not been standardized. The wiring configuration - single phase, three phase - can vary for the same voltage from country-to-country as well. Three phase services are typically used for commercial and industrial applications as they run motors more smoothly and can supply more current at the same voltage compared to non-three phase services. See Voltage and frequency by country for the voltage and frequency for specific countries.

AC or DC?

If so many appliances internally function on DC, why not just use direct current for every circuit then? Each one has different characterstics that make it useful for certain applications. AC has important properties that make it useful in the electrical grid. It is cheaper to transmit AC over long distances as it is easier to change between high and low voltages. High voltages are ideal for long distance transmission as they require less current, which means you can use smaller wires. DC works well in off-grid applications as PV modules produce DC and batteries store energy in DC, meaning that using AC appliances requires the added expense and loss of efficiency that come with an inverter.